Toolbar

Help Contents

Introduction

When the Operator Interface is connected to a Fernhill SCADA Server, a toolbar is displayed:

Operator Interface toolbar

Note: This image shows the default toolbar. Your system integrator can change the toolbar to show different options. The icons you see may be different to those shown here.

The toolbar may be displayed vertically or horizontally. The operator interface chooses an orientation that gives the maximum area to the current page on display.

The default toolbar provides these commands:

ToolDescription
Navigate back buttonNavigates back to the previous page.
Navigate forward buttonNavigates forward to the next page.
Navigate forward buttonNavigates to the home Graphic Page.
Alarm bell button The Alarm Bell button flashes when new alarms occur.
Click on the alarm bell button to cancel the flashing effect and display the Alarm List Page showing the current alarms.
Show events buttonDisplays a List Page showing the most recent events.
Menu buttonOpens the Operator Interface Menu.

Note: Commands not available are dimmed.

Toolbar Tooltips

If you position the mouse over a toolbar button, a tooltip will be displayed providing more information about the button:

Toolbar tooltip

Note: This image shows the default tooltip for the alarms icon. Your system integrator can change the toolbar to show different information in each tooltip. The information you see may be different to that shown here.

To open the Operator Interface Menu, click the top right menu icon Menu icon.

The Operator Interface Menu provides these commands:

Menu CommandDescription
Disconnect The Disconnect command does the following:
  1. Disconnects the Operator Interface from the Fernhill SCADA Server.
  2. Displays the Start Page.
Reset View Resets the current display to its default position.
Save As... Saves the current display to a file.
Print... Prints the current display.
Note: This option is not currently available on the Linux version of the Operator Interface.
Help Displays this help page.
Note: This option is not currently available on the Linux version of the Operator Interface.
About Displays a dialog showing the version information of the Operator Interface.

Note: Commands not available are shown in gray.

Further Information

Operator Interface

To learn more about the Operator Interface.

Glossary

For the meaning of terms used in Fernhill SCADA.